Cost guide · Updated Aug 14, 2026
Electrician cost in Cleveland in 2026
Cleveland electricians run $80 to $150 per hour in 2026 — median around $108. A 200A panel upgrade lands $1,900 to $4,400. Rewiring costs far more in a masonry house than the same square footage of frame construction, and much of this city is brick.
Typical range
$80 – $150 / hr
~$108/hr · 200A panel upgrade $1,900 – $4,400 all-in
By scope
| Scope | Price | Notes |
|---|---|---|
| Service call / diagnostic | $70 – $165 | Often credited toward the work |
| Outlet, switch, or fixture replacement | $105 – $230 per device | |
| New dedicated circuit | $380 – $1,000 | |
| 200A panel upgrade | $1,900 – $4,400 | Includes permit and utility coordination |
| Whole-house rewire (century home) | $9,000 – $26,000 |
What swings the price
- Masonry construction, where there is no stud cavity to fish a wire through.
- Knob-and-tube and cloth wiring across the older housing stock.
- Plaster walls, which mean patching and repainting after any wall opening.
- Third-floor and attic circuits in tall century homes with long runs.
Cleveland specifics
A frame house lets an electrician fish new wire through stud cavities with minimal damage. A solid masonry house does not — there is no cavity, so the options are surface-mounted conduit, chasing channels into plaster and brick, or routing through closets and floor structures. That is why a rewire quote on a brick Cleveland century home comes in well above what the square footage suggests, and why two quotes can differ wildly depending on which approach each one assumes. Ask specifically how they plan to route the new circuits before comparing numbers.
Skip the calling
Get real Cleveland quotes for $5.99
The ranges above are what you should expect. To get real numbers from real Cleveland pros — anonymously, without handing your phone to a lead-gen marketplace — we dial local pros for you and email you a one-page comparison. Full refund if we land fewer than 2 quotes.
FAQs
How much does an electrician cost per hour in Cleveland?
$80–$150/hr, median around $108, with a service-call fee of $70–$165 usually credited toward the work. Cleveland is among the more affordable electrical markets in the country.
Why does rewiring a brick house cost more?
There is no stud cavity to fish through. Circuits have to run in surface conduit, in channels cut into plaster and masonry, or through closets and floor structures. All three cost more than pulling wire through a frame wall.
What does a whole-house rewire cost in Cleveland?
$9,000–$26,000 for a century home depending on size, construction, and how much finish work is involved. Get the routing approach in writing — that assumption is why two quotes for the same house can differ by thousands.
Should I rewire or just upgrade the panel?
They solve different problems. A panel upgrade gives you capacity and modern protection; it does nothing about deteriorated cloth or knob-and-tube wiring in the walls. An electrician should assess the branch wiring before you decide.
Does Ohio license electricians?
Yes, electrical contractors are licensed by the state board while permits and inspection are handled locally. Verify the license and confirm the contractor regularly permits work in your municipality.
Sources
Related cost guides
Electrician hourly + panel upgrade
Electrician cost in New Orleans in 2026
$85 – $160 / hr
Electrician hourly + panel upgrade
Electrician cost in Raleigh in 2026
$85 – $155 / hr
Electrician hourly + panel upgrade
Electrician cost in Oklahoma City in 2026
$75 – $145 / hr
Handyman hourly rate
Handyman cost in Cleveland in 2026
$55 – $100 / hr
Prices refresh quarterly. Last review: Aug 14, 2026.