Cost guide · Updated Aug 9, 2026
Electrician cost in San Antonio in 2026
San Antonio electricians run $80 to $150 per hour in 2026 — median around $105. A 200A panel upgrade lands $1,900 to $4,200. The city's utility is municipally owned, which makes the rebate landscape and the service-coordination process different from most Texas metros.
Typical range
$80 – $150 / hr
~$105/hr · 200A panel upgrade $1,900 – $4,200 all-in
By scope
| Scope | Price | Notes |
|---|---|---|
| Service call / diagnostic | $65 – $155 | Often credited toward the work |
| Outlet, switch, or fixture replacement | $105 – $230 per device | |
| New dedicated circuit | $350 – $950 | |
| 200A panel upgrade | $1,900 – $4,200 | Includes permit and utility coordination |
| Whole-home surge protector | $350 – $750 |
What swings the price
- Municipal utility coordination for service disconnects and meter work.
- Utility rebate programs for efficiency work, which can offset part of an upgrade.
- Summer attic heat, which limits when overhead runs can be pulled.
- Older Southtown and Monte Vista homes with obsolete service equipment.
San Antonio specifics
San Antonio's electric utility is owned by the city rather than by investors, and it runs its own efficiency rebate programs — which means some electrical work here gets partially funded in ways that do not exist in deregulated Texas markets. The catch is that rebates almost always require pre-approval before the work starts and use of a participating contractor. Ask about current programs at the quote stage; asking after the panel is installed is asking too late.
Skip the calling
Get real San Antonio quotes for $5.99
The ranges above are what you should expect. To get real numbers from real San Antonio pros — anonymously, without handing your phone to a lead-gen marketplace — we dial local pros for you and email you a one-page comparison. Full refund if we land fewer than 2 quotes.
FAQs
How much does an electrician cost per hour in San Antonio?
$80–$150/hr, median around $105, with a service-call fee of $65–$155 usually credited toward the work. Rates run below Austin and Dallas for equivalent work.
Are there rebates for electrical work in San Antonio?
The municipal utility runs efficiency programs that periodically cover equipment and related electrical work. Most require pre-approval and a participating contractor, so raise it while you are still collecting quotes rather than after the job.
What does a 200A panel upgrade cost in San Antonio?
$1,900–$4,200 all-in including permit, inspection, and utility coordination. Older homes needing a new service mast or a meter relocation run toward the upper end.
Is a whole-home surge protector worth it here?
Often yes. Central Texas gets frequent severe storms, and a panel-mounted surge protective device at $350–$750 installed is inexpensive compared with the electronics and HVAC boards it protects. It is one of the better value electrical add-ons in this market.
Does my electrician need a Texas license?
Yes. Electrical contractors must hold a state license to pull permits, and individual electricians are licensed at apprentice, journeyman, or master level. Verify the number with the state before work starts.
Sources
Related cost guides
Electrician hourly + panel upgrade
Electrician cost in Las Vegas in 2026
$90 – $165 / hr
Electrician hourly + panel upgrade
Electrician cost in Portland in 2026
$110 – $190 / hr
Electrician hourly + panel upgrade
Electrician cost in Boston in 2026
$125 – $225 / hr
Junk removal
Junk removal cost in San Antonio in 2026
$110 – $800
Prices refresh quarterly. Last review: Aug 9, 2026.