Cost guide · Updated Aug 14, 2026
Handyman cost in Tampa in 2026
A handyman in Tampa runs $60 to $110 per hour in 2026 — median around $82 with a two-hour minimum. Hurricane shutters need to be fitted, labeled, and test-hung in July, because the week a storm enters the Gulf is the week every handyman in the bay is already booked.
Typical range
$60 – $110 / hr
~$82/hr · 2-hour minimum typical
By scope
| Scope | Price | Notes |
|---|---|---|
| Independent / solo | $50 – $78 / hr | |
| Established local company | $78 – $110 / hr | |
| Licensed contractor doing small work | $95 – $145 / hr | |
| Shutter fit, label, and test hang (whole house) | $350 – $900 | Pre-season job |
| Full-day package (8 hr) | $490 – $820 |
What swings the price
- Pre-season shutter fitting, which is a July job and impossible to book in September.
- Salt air corrosion on fasteners, tracks, and anchors near the water.
- Soffit and vent repair, which is where wind-driven rain gets into an attic.
- Summer heat and afternoon storms, which compress outdoor work into mornings.
Tampa specifics
Shutter panels do not fit themselves. Anchors seize with corrosion, panels get mixed up between openings, wing nuts go missing, and a set that went up fine three years ago will not go up at all in a hurry. The right time to find that out is a calm week in July: have someone fit every panel, label each one to its opening, replace corroded anchors, and store them in order. When a storm is named, the entire trade is booked and the hardware stores are empty — that is not the week to discover the third-bedroom panel is the wrong one.
Skip the calling
Get real Tampa quotes for $5.99
The ranges above are what you should expect. To get real numbers from real Tampa pros — anonymously, without handing your phone to a lead-gen marketplace — we dial local pros for you and email you a one-page comparison. Full refund if we land fewer than 2 quotes.
FAQs
How much does a handyman cost per hour in Tampa?
$60–$110/hr, median around $82, with a two-hour minimum common. Licensed contractors taking small work charge $95–$145/hr.
When should I have hurricane shutters fitted?
July, before the peak of the season. Fitting, labeling, and test-hanging every panel takes a few hours and costs $350–$900 for a whole house. Once a storm is named, no one is available and the hardware is gone from the shelves.
Can a handyman install hurricane shutters?
Fitting, servicing, and hanging existing approved panels is generally handyman scope. Installing new shutters or impact windows is not — those are building envelope products requiring approved assemblies, permits, and a licensed contractor.
What else should be checked before storm season?
Soffit and vent security, since wind-driven rain enters attics there; gutter and downspout clearance; loose fascia; and anything in the yard that becomes a projectile. Roof straps and tie-downs are an inspector's job rather than a handyman's.
Does Florida license handymen?
Florida licenses specific trades and contractors above certain scopes, and local jurisdictions add their own requirements. General repair work usually does not require a license, but anything structural, electrical, plumbing, or envelope-related does.
Sources
Related cost guides
Prices refresh quarterly. Last review: Aug 14, 2026.